ASSEMBLY INSTRUCTIONS
INSTRUCCIONES DE ENSAMBLE
INSTRUCTIONS D ASSEMBLAGE
NOTE: Do not tighten until all bolts are assembled.
NOTE: No ajuste hasta que todas las tuercas estén ensambladas.
REMARQUE : Ne pas serrer tant que tous les boulons ne sont pas montés.
1.
1.
1. Assemble two washers (6)) onto each end of the roller.
2. Assemble a ûange bearing (5)
through each hitch tube (3) so that the ûange will face toward the roller. (To assemble, you may need to carefully tap against the
ûange bearing with a block of wood or a hammer.)
3. Place the hitch tubes (3) onto both ends of the roller. Assemble the scraper bar (2) to the hitch tubes using two hex bolts (9)
and hex lock nuts (10).
4. Assemble the hitch tubes (3)
together using two hex bolts (7)
and hex lock nuts (10).
5. Assemble the hitch brackets (4)
to the hitch tubes (3) using two hex bolts (8) and hex lock nuts
(10). Tighten all bolts at this time.
6. Adjust plug (11) size by twisting handle. Lock plug in roller drum by ûipping handle down.
Ref.
No.
Part
No.
_smart_usb_mention.jpg)
