øÿ MacBook (13-inch, Late 2009)/(13-inch, Mid 2010)
Hard Drive
Replacement Instructions
Follow the instructions in this document carefully. Failure to follow these instructions could damage your equipment and void its warranty.
Online instructions are available at http://www.apple.com/support/diy/.
Note: This procedure is for MacBook (13-inch, Late 2009) and MacBook (13-inch, Mid 2010)
models. Although your model may look slightly different from the one shown in the illustrations,
the steps are the same.
Important: Make sure data is backed up before removing the hard drive and restoring software.
Apple is not responsible for any lost data.
Tools Required
" Clean, soft, lint-free cloth
" ESD wrist strap, if available
" Magnetized Phillips #00 screwdriver
© 2010 Apple Inc. All rights reserved.
073-1316 Rev. B 1
Removal
Important: Make sure data is backed up before removing the hard drive. Apple is not responsible for any lost data.
1
Shut down computer.
2
Unplug all cables.
3
Put on ESD strap or touch metal to discharge electricity.
Caution: To prevent scratches to the case, use a protective cloth when working with metal tools.
Important: The screws at the sides and front of the computer must be removed and installed at an angle.
4
Remove 8 (4.3-mm) screws.
Replacement Note: Install screws in the order shown.
© 2010 Apple Inc. All rights reserved.
073-1316 Rev. B 2
_funktionshandbuch.jpg)
